Oxford Ball Point Pen [Help]

Signed-In Members Don't See This Ad
Status
Not open for further replies.
Bozz

Bozz

Member
Joined
Nov 1, 2006
Messages
40
Location
(Fair Oaks) 50 & Hazel Ave, CA, USA.
If any one has the dimensions of Woodcraft bushing #06R07 I would appreciate a post. I'm going to make my own bushings out of aluminum and need the specs: Large Diamter; Small Diameter; and Tube Lip Diameter needed.


200712723042_oxford%20bushing.jpg


This kit uses three identical bushings. Any help is appreciated. By the way, I am making an Oxford Ball Point Pen #129854 from Woodcraft:



20071272359_oxpen.gif



Thank you,
Bozz in Fair Oaks, California
 
Signed-In Members Don't See This Ad
Measure the outside diameter hardware that fits against the wood and the inside diameter of the tube and those will be the dimensions that you need.
 
The best I can measure on mine, that have been used about 6 times. ia Lip0.287 small end 0.390 and large end 0.489
 
Stan, Reed and Tom,
Thanks for everyones input. Stan, I measured the parts and compared them with the caliper readings from Reed and Tom. Reed and Tom, your measurements were right on the money. They matched up to the kit perfectly [you guys must have collaborated]. Thanks, everyone for your efforts, it really is appreciated. The IAP is a wonderful thing!

Bozz in Fair Oaks, California
 
Status
Not open for further replies.
Back
Top Bottom