MRDucks2
Member
This is listed on AAW by a fellow in Chattanooga, TN. He isn't sure if it will get much interest there as it is a smaller, starter size setup for them. If interested, let me know and will put you in touch. He did say someone intended to look at it this weekend and it is listed on Facebook.
Along with the lathe/stand, I'm including the following (a few of the following items are normally included with a lathe, of course):
posted on AAW by
Michael Anderson
Chattanooga, Tennessee
maa198@gmail.com
Along with the lathe/stand, I'm including the following (a few of the following items are normally included with a lathe, of course):
- Nova G3 chuck with three sets of jaws: 25mm, 50mm and 100mm
- Nova mini chisel tool set (1/8" spindle gouge, 1/4" spindle gouge, 1/8" parting tool, 1/4" round nose scraper, and 1/4" skewed scraper)
- Nova 6" tool rest
- Robust 9" comfort tool rest
- 3" faceplate
- 1" 4-prong drive center
- Cupped live center
- Cone live center (60 degrees)
- Wrench, a couple of hex keys, and original rubber feet that came with the lathe
- Knockout bar
posted on AAW by
Michael Anderson
Chattanooga, Tennessee
maa198@gmail.com
Last edited: