MT2 round collets

[RHossack]

Anyone know if they make a 3/4" round collet? My er32 goes to 1/2" but would like one round collet that is 3/4".

I guess I could buy a er32 spring collet in 19mm and that would be close but would like a round one ...

 

[its_virgil]

ER32collets go up to 3/4 "
http://littlemachineshop.com/products/product_view.php?ProductID=2559&category=

check ebay for better prices.

Do a good turn daily!
Don

Anyone know if they make a 3/4" round collet? My er32 goes to 1/2" but would like one round collet that is 3/4".

I guess I could buy a er32 spring collet in 19mm and that would be close but would like a round one ...

 

[jleiwig]

Anyone know if they make a 3/4" round collet? My er32 goes to 1/2" but would like one round collet that is 3/4".

I guess I could buy a er32 spring collet in 19mm and that would be close but would like a round one ...

Do you mean an MT2 taper collet

 

[PTownSubbie]

Ron,

I have ER32 collets left over from my PSI Collet Chuck that I don't use. I have the following sizes: 1/4", 3/8", 1/2", 5/8" and 3/4".

PM me and I am sure we can work something out.

 

[RHossack]

Do you mean an MT2 taper collet

Yes, that was what I intended to say.

 

[johnnycnc]

Ron, I don't believe you will find a MT2 taper collet in 3/4",
since most MT2 bores are smaller than that in theirself, at their largest.

For reference, the large diameter on a MT2 dead center is around 3/4",
and that sticks out of the spindle bore.

Here is a link to a set, largest is 1/2" bore;
http://www.shars.com/products/view/674/2_Morse_Taper_Round_Collet_set

 

[RHossack]

Ron, I don't believe you will find a MT2 taper collet in 3/4", since most MT2 bores are smaller than that in theirself, at their largest.

Thanks for the clarification and I suspected as much ... I see they do make it in MT3 which would fit in the metal lathe.