USAFVET98
Member
I am in need of a machinist capable of making me about 100+ small (under 1/4" pins of my design. These pins have to have a small ridge to allow for a spring to attach to it. Basically the spring will attach and hang off of the pin..
Anyone up for the challenge? I designed a special part and want to manufacture it to subsidize my income. If not, anyone know of a company that can produce these at a decent rate? The finished product will sell for around $1.50. So I'm looking to get the cost below $.75 per unit.
Anyone up for the challenge? I designed a special part and want to manufacture it to subsidize my income. If not, anyone know of a company that can produce these at a decent rate? The finished product will sell for around $1.50. So I'm looking to get the cost below $.75 per unit.
