Little Goblets

[Dai Sensei]

I decided to have a go at miniature goblets from Queen Ebony. I did cut in too deep on the stem of the smallest one just below the cup, but considering it is less than 1/4" high, I thought I didn't do too bad. The coin they sit on is our 10 cent piece, similar to your dime. The different shapes were deliberate. They are so small even dust shows up in the photo :tongue:

Cheers

 

[plantman]

Well, I would think you could have more than one drink and still be able to drive without being over the limit !! Very well done !! Smaller is not easier. Jim S

 

[Bob Wemm]

Very nice Neil,
The ones I made were hard enough but these are about half that size, so I can imagine the difficulties.
You didn't sand and polish them?? LOL.
Thanks for sharing.
Bob.

 

[walshjp17]

Nice work. What did you use to hollow out the bowls? A nail?:wink::biggrin:

 

[Dai Sensei]

What did you use to hollow out the bowls? A nail?:wink::biggrin:

Started with a drill then shaped them with a dental picks sharpened as scrapers

All of them started with captured rings, also done with sharpened dental picks, but none survived :redface: