ToddMR
Member
So I recently replaced the wave washer on my Jet lathe and just wanted to make sure its in the right spot. My old one was broke into two pieces, not sure how that happened. I have been searching high and low online and not finding anything. I took out the two set screws to the hand wheel took it off slid the wave washer on, replaced the wheel then put the set screws in the same spot as there were markings from when I took out the screws. Do I have to place the wave washer anywhere special or is how I did it correct? I have found no real directions with pics or video online, or anything else really other than the bearing replacement directions here on IAP which I don't quite understand what its talking about.
If someone could help me I would appreciate it.
If someone could help me I would appreciate it.