Four Sierra blanks, two have circles and two have hexagons. I'm thinking of leaving one of each as is, and fill with CA and painting the other two. Trying to figure out if I can just paint the whole blank or if I need to hand paint each little circle or hex. To my eye these small patterns are leaps and bounds better than a larger design wrapped around. Ideas on the painting are welcomed.
Circles and Hexagons
- Thread starter KenB259
- Start date
Signed-In Members Don't See This Ad
1080Wayne
Member
! would paint all over , sand , then CA , but perhaps the designer needs some punishment for making these blanks , and should do the engravings individually . Agree , looks much better than a large image wrapped around the blank , but a bit too busy to my eyes .
Woodchipper
Member
Unique to say the least and creative. I tried drilling a wood blank and gluing dowel in the holes. Wound up with gaps between the dowel and blank.
