jcollazo
Member
Let's say I'm using one of Gadget's molds... 4 blanks, horizontal. Can the molds be stacked so that I can get 8, 12, or 16 blanks per casting session?
That's all.[8D]
That's all.[8D]
Another ? about using the HF pot.
- Thread starter jcollazo
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
Dan_F
Member
Umm...not if you're using "one". 
Dan
Dan
wdcav1952
Activities Manager Emeritus
Originally posted by Dan_F
Umm...not if you're using "one".
Dan
ROTFLMAO!!!!
LEAP
Member
Good one Dan! I'm on the floor as well.
Joe, I made little platforms that keep about a half inch of space above the mold and stack four molds in the pot.
Joe, I made little platforms that keep about a half inch of space above the mold and stack four molds in the pot.
gketell
Local Chapter Leader
a friend of mine just rotates the molds 90 degrees and stacks them on top of each other. No problems
Jarheaded
Member
I have no problem going four high, just make sure that the air is not blowing down into the resin or you will have a mess.
JayDevin
Member
I have stacked 2 on top of each other turned 90 degrees, top one just peels off the bottom one!
jcollazo
Member
'Ya know.. .I thought my question over on the way out this evening. Realized what I had asked and just knew the types of answers I would get[:0]
Thanks for the answers and the chuckles.
Thanks for the answers and the chuckles.