Aero Bushings

[PMisiaszek]

I'm looking for a set of Aero turn-between-centers bushings. John no longer lists them.

 

[Adillo303]

When I turn between centers, I dont use bushings. I use my digital calipers, measure the kit parts and turn that size. Then I sand and build back to that size with my CA.

 

[longbeard]

Peter, you can use the factory bushings for between centers to get your blank turned down to a point that is still proud of the componenets, then remove those bushings and put the blank between centers and finish turning to size (this will also help if those factory bushings are out of round, which most are). Turn a little bit, mic the blank. Hope this helps you and not confuse you.