.308 tube rings

Signed-In Members Don't See This Ad
R

RDH79

Member
Joined
Mar 25, 2008
Messages
1,597
Location
Rimersburg, Pa, USA.
Not sure what there called but I'm looking for the collars for the .308 casing. It's a spacer on the tip bullet end because the 7mm tube is to small and doesn't fit tight. I use to buy the fro Woodturningz or Woodnwhimizies. Can't find them on there site.
Thank You for any information
Rich
 
Signed-In Members Don't See This Ad
Neat idea with the collars. I've never used them. I just use thick super glue on the collar end & use a small dowel rod to center the tube & then spray some accelerant on it.

I've heard of some people using heat shrink tubing to do the same thing as you are wanting to do.
 
Sataro said:
Neat idea with the collars. I've never used them. I just use thick super glue on the collar end & use a small dowel rod to center the tube & then spray some accelerant on it.

I've heard of some people using heat shrink tubing to do the same thing as you are wanting to do.
Click to expand...
That is the way I leaned many years ago when these first started appearing here. Soldered the tube in.
 
I think it was Wood-n-whimzies.
But they don't seem to sell a lot of the things they use to sell.
I'm sure I have some but After 20 years of making pens for a business I have stuff everywhere to look through.
 
I started using 8 mm tubes. Drill out the primer for an 8 mm tube and the bullet end fits snug. I epoxy that then put a couple of wraps of scotch tape around both ends of the 7mm tube. Not much just about an 1/8". Then I epoxy glue that inside the 8mm tube. I haven't had any trouble with alignment or slippage. The tape sounds a little cheesy but there's not much of it.
 
You must log in or register to reply here.
Back
Top Bottom