ryjonesacct
Member
I recently got started turning pens and turning in general, and quickly realized I need to sharpen my chisels. Everywhere I looked it seemed like the Wolverine sharpening jig was the way to go. So I forked over the $90 for the jig, but now I am trying to figure out how to install it with my grinder. Is the wolverine jig system supposed to come with hardware to install the bases? Mine didn't there are some really small screws and some sheet metal pieces that I'm not sure how they fit in. Also it comes with some very basic instructions, but not very in depth. Am I just being stupid and I should just screw it in with whatever I have lying around the shop? I just feel a little ripped off for paying $90 and they don't even give you anything to install it and get you up and running. Also what are the sheet metal parts for? and where do they fit in. Sorry I hope this is the right forum for this question, I figure someone out there has the jig and knows what to do. Thanks in advance