Jeff G
Member
Hi All
I asked this question in the caliper thread but thought it would be a good one on its own...
What do you allow in terms of 'over-sizing' your work before sanding?
Some one had suggested this...
What seems to work for me is I measure the pen fitting add 2 thou. and sand with 220 or 240 grit to that. Then light sanding with 320 and 600 add my CA finish and 99% of the time am right on the money
And I was curious if this is about what others are figuring for "oversizing" before sanding to final size AND keeping in mind the thickness of the ca finish?...
Thanks as usual...
JeffG
I asked this question in the caliper thread but thought it would be a good one on its own...
What do you allow in terms of 'over-sizing' your work before sanding?
Some one had suggested this...
What seems to work for me is I measure the pen fitting add 2 thou. and sand with 220 or 240 grit to that. Then light sanding with 320 and 600 add my CA finish and 99% of the time am right on the money
And I was curious if this is about what others are figuring for "oversizing" before sanding to final size AND keeping in mind the thickness of the ca finish?...
Thanks as usual...
JeffG