I have only made about 20 pens so far. I went to Woodcraft for the first time. Great people! I saw a wall street 3 circuit board pen that I wanted to make. I bought a kit and the bushings. The problem I did not realize until I BUILT the pen was that the bushings were for the Wall street 2!! I assembled the pen hoping for the best:frown:. I was wrong. The pen is obviously off by that little bit. I might be new but I know it does not feel right. My question is: can I dissassemble it and but a new kit and bushings and switch out the blanks? Also where is the chart that shows what bushings are interchangable? Thanks in advance.