Fish30114
Member
I recently built 3 kits and learned when I began to assemble them that the tubes included in the kits were slightly oversized. It's just shy of a press fit in two ends of the tubes, and on the third there is quite a bit of 'slop' I am looking for advice on how to salvage these kits tubes, all 3 I was fortunate to have done a nice job on the turning for all 3 of the tubes, and I do want to save them--2 nice acrylic blanks and one nice piece of Cocobolo.
I don't know if CA will fill enough on the one that has the most slop, it would probably build up enough for the other two.
Thanks for any insight/advice.
I don't know if CA will fill enough on the one that has the most slop, it would probably build up enough for the other two.
Thanks for any insight/advice.