juteck
Member
Probably not a new idea, but I thought I'd share it anyways. When I have a lot of tubes to sand, I use a sanding drum and old sleeve on my drill press. You may have to move the table out of the way.
Put a tube on a screw driver, hold it against the spinning drum somewhere between 45- and 90-degrees, and let the tube spin on the screwdriver as the sanding drum "drives" it.I do about 1/2 the tube, then flip it over and do the other half, so I'm only working the top half and keeping the handle of the screwdriver away from the drum.
Put a tube on a screw driver, hold it against the spinning drum somewhere between 45- and 90-degrees, and let the tube spin on the screwdriver as the sanding drum "drives" it.I do about 1/2 the tube, then flip it over and do the other half, so I'm only working the top half and keeping the handle of the screwdriver away from the drum.