S
spiritwoodturner
Guest
I'm kinda thinking out loud here, because I could go out and measure every set of bushings I have to get this info. But I'm working on Alabaster in PR blanks, and have tried a few on El Grande kits, mainly because I have a boatload of them and they're cheap. The 2 I've tried have been fine until I get almost done, then I go right through the Alabaster to the tube with final sanding. These kits are about 2 paper width thickness, so I'm thinking about what to try next. Maybe a cigar?
Your thoughts?
Dale
Your thoughts?
Dale