sschering
Member
I need to get a spur center for my not so normal lathe.
I don't have a Taper head stock so what I need is one I can chuck in a 5/8 or 1/2" collet chuck.
So far all I've found is shop smith drives that fit over a 5/8 shaft.
I could make that with with a piece of drill rod but I'd rather chuck it directly.
One less thing to add run out.
The Nova chuck drives are square and I need round.
I don't have a Taper head stock so what I need is one I can chuck in a 5/8 or 1/2" collet chuck.
So far all I've found is shop smith drives that fit over a 5/8 shaft.
I could make that with with a piece of drill rod but I'd rather chuck it directly.
One less thing to add run out.
The Nova chuck drives are square and I need round.