G
Guest
Guest
I bought some stabilized dyed box elder burl from Bill at A.S.
In the prcess of turning I kept getting the impression I was turning something that was more acrylic than wood.
I did a seal coat of thn CA and proceeded to sand starting with steel wool(XXXX) then 400 through 12000 mm
Is any other finish necessary?
I did wind up using the Mylands sealer,polish and carnauba,Finally President Choice (D.C.'s stuff)something I would do to a wood blank but not a plastic one.)(Mylands I use D.C.'s stuff on everything)
I guess my question is:
Is a commercially stabilized blank such as this considered wood or plastic?
In the prcess of turning I kept getting the impression I was turning something that was more acrylic than wood.
I did a seal coat of thn CA and proceeded to sand starting with steel wool(XXXX) then 400 through 12000 mm
Is any other finish necessary?
I did wind up using the Mylands sealer,polish and carnauba,Finally President Choice (D.C.'s stuff)something I would do to a wood blank but not a plastic one.)(Mylands I use D.C.'s stuff on everything)
I guess my question is:
Is a commercially stabilized blank such as this considered wood or plastic?