MartinPens
Member
This was super simple guys and gals. Used a punch tool to disassemble the cap. Mounted the top cap piece into my PSI micro chuck. Drilled a hole (7/32). Bought a boot shoestring (bootstring?) and put it through the hole - tied a knot - put a spot of CA on the knot and cut the extra off and trimmed it close. It all pokes inside the cap piece. I left off the clip since it's not needed anymore and reassembled. Snakeskin blank is from Seamus7227. Thanks Seamus!
So nice to do something in 30 minutes during a rushed day and have it turn out.
p.s. Make sure you give the cap time to de-gas if you use CA on the knot. This will be a popular alteration for sure.
Martin
So nice to do something in 30 minutes during a rushed day and have it turn out.
p.s. Make sure you give the cap time to de-gas if you use CA on the knot. This will be a popular alteration for sure.
Martin