bgio13
Member
A customer was interested in a stylus, so I ordered the stylus conversion kit from PSI to use on a slimline kit I already had. I pressed the threaded cap nut in and when I screwed the stylus cap in I noticed the hole in the slimline clip was larger than the threads on the stylus cap. The fit was loose and the clip wobbled around. I knocked the threaded cap nut out a bit so it wasn't flush with the end of the wood and then pressed everything together using a wood block with a hole in it. That seemed to work as the hole in the clip is the same diameter as the cap nut. So, I was wondering if this is an acceptable fix, or if the cap nut will be pushed in with use, thus making the clip loose again. Thanks,
Bill
Bill