JohnGreco
Member
Hey folks, I need a bit of a hand. I just assembled a slimline pro (PSI) that doesn't want to stay extended. When I click to extend the ink, it extends, then slowly makes its way back into the housing until the tip is barely visible.
Did I do something wrong? Is there a way to salvage this blank? (It is historic wood that has been engraved, so am really hoping the material is at least able to be kept intact)
Thanks in advance for any ideas/suggestions/luck you can send my way
Did I do something wrong? Is there a way to salvage this blank? (It is historic wood that has been engraved, so am really hoping the material is at least able to be kept intact)
Thanks in advance for any ideas/suggestions/luck you can send my way