BillyBoy63
Member
I need some help I have a carbide 3/8 gouge from PSI .
My question is what is the best way to get it sharpened ?
I though I saw or heard some were that you should not put it to a grinder
is that right ?
Also I don't want to have to start a new thread about a tool rest so I will add it here
I'm looking to find a tool rest that looks like a robust comfort rest
I need a 5/8 shaft but I don't want the little one that don't reach in as far
I want it to reach in farther like the one for the one inch shaft
Is there anyone here that could make one if they understand what I'm talking about
BillyBoy63
My question is what is the best way to get it sharpened ?
I though I saw or heard some were that you should not put it to a grinder
is that right ?
Also I don't want to have to start a new thread about a tool rest so I will add it here
I'm looking to find a tool rest that looks like a robust comfort rest
I need a 5/8 shaft but I don't want the little one that don't reach in as far
I want it to reach in farther like the one for the one inch shaft
Is there anyone here that could make one if they understand what I'm talking about
BillyBoy63