K
kooseman
Guest
I have a Jet 141I belt driven mini lathe. Changing belts is not a major issue but I would like some advice on changing speeds during finishing. I turn at full speed and then reduce speed to around 800+ to complete all sanding steps. I then change to full speed for applying a finish. Do I need to change or modify speeds during sanding??
Also, when I complete sanding my wood blanks (150 - 12000 MM), I apply some EEE prior to Shellawax. Is this in fact necessary or does it actually reverse the sanding finish back down to a lower grit. My understanding is that EEE substitutes for certain grits of sandpaper.
Thanks for all the advice.
Also, when I complete sanding my wood blanks (150 - 12000 MM), I apply some EEE prior to Shellawax. Is this in fact necessary or does it actually reverse the sanding finish back down to a lower grit. My understanding is that EEE substitutes for certain grits of sandpaper.
Thanks for all the advice.