LagniappeRob
Member
I know it's not up to the standards of some of the guys around here... I'll get there one day, maybe.
I was pretty worried about this blank. It had a distinct bend in it. I figured worst case is I pull it back apart and pick up some new tubes and try again with another. That bend area is right below the cap in the picture, and produced the nicest of figure. The blank came from Mike and Saundra at LogsToLumberExotics - great people!!
C&C welcome and appreciate. Remember I've only been doing this for ~ 6 months.
Edit - The photo was just a quickie setup (no lights or anything, and just against a t-shirt) so I could post it.
I was pretty worried about this blank. It had a distinct bend in it. I figured worst case is I pull it back apart and pick up some new tubes and try again with another. That bend area is right below the cap in the picture, and produced the nicest of figure. The blank came from Mike and Saundra at LogsToLumberExotics - great people!!
C&C welcome and appreciate. Remember I've only been doing this for ~ 6 months.
Edit - The photo was just a quickie setup (no lights or anything, and just against a t-shirt) so I could post it.