Jeremymc98
Member
I am a rookie at turning and when I first received my turncrafter and noticed the tail stock wiggle I didn't know it could cause issues.
My questions is:
The tailstock can wiggle almost 1/8" along the axis of the lathe bed. It locks in tight but at times when drilling blanks it causes alignment issues. Does anyone know 1. If there is a way to adjust out the slop. 2. How do I do it if possible.
Thanks in advance. Everyone here is always tremendously helpful
My questions is:
The tailstock can wiggle almost 1/8" along the axis of the lathe bed. It locks in tight but at times when drilling blanks it causes alignment issues. Does anyone know 1. If there is a way to adjust out the slop. 2. How do I do it if possible.
Thanks in advance. Everyone here is always tremendously helpful