hrigg
Member
Not sure if this is advanced enough for that forum, but I'm looking for some feedback for this...
It's a rosewood rollerball, with a double closed end, a recessed clip and a snap cap. It's made from three different Berea kits, and a nylon washer provides the snap feature. The washer was trimmed down to fit inside the Robusto CB, and it's currently held in by epoxy. The cap has survived a week of being taken on and off, but I'm uncertain about how long it will last. For that reason, plus still needing to build another one, I'm not ready to declare it a success. Here's a picture with the cap off...
The recessed clip is held in with epoxy only, and the pen is a little rough because there is no finish. The next one will have a slightly longer cap and a dowel to help hold in the clip.
Your thoughts, please?
It's a rosewood rollerball, with a double closed end, a recessed clip and a snap cap. It's made from three different Berea kits, and a nylon washer provides the snap feature. The washer was trimmed down to fit inside the Robusto CB, and it's currently held in by epoxy. The cap has survived a week of being taken on and off, but I'm uncertain about how long it will last. For that reason, plus still needing to build another one, I'm not ready to declare it a success. Here's a picture with the cap off...
The recessed clip is held in with epoxy only, and the pen is a little rough because there is no finish. The next one will have a slightly longer cap and a dowel to help hold in the clip.
Your thoughts, please?