Hi all, I wonder if anyone else has had any problem with the Broker pen. (I imported a handful from CSUSA) 1st is when finished, the refill sticks out the nib too far. 2nd is the cap. I thought I had turned a couple of them off centre as the cap sat very poorly. My quick fixes are to pull the plastic bit off the end of the refill and file a bit of the refill till it looks right. The cap was a bit trickier. I discovered that a brass tube actually can slide a couple of mm into the cap between the cap sleeve and the black part, so I wrapped my finished blank in insulating tape,
stuck it in the lathe and took a bit off the wood down to the brass.
Works a treat, but when the refill gets changed, it will stick out again.
I haven't seen any postings of this pen either?
Looking forward to comments
Skiprat
stuck it in the lathe and took a bit off the wood down to the brass.
Works a treat, but when the refill gets changed, it will stick out again.
I haven't seen any postings of this pen either?
Looking forward to comments
Skiprat