ryannmphs
Member
OK, so the last couple of pens I have turned (one is still on the lathe) I have gone so far as getting the finish applied before realizing, "I don't like the way it looks". Maybe the finial end is too round withour enough taper to the body, or there's too much of a taper.
Does this happen to anyone else? And, when you do realize the design is not right, even if your finish is applied and you are ready to remove the blanks from the mandrel, do you try to adjust the design and refinish?
Ryan
Does this happen to anyone else? And, when you do realize the design is not right, even if your finish is applied and you are ready to remove the blanks from the mandrel, do you try to adjust the design and refinish?
Ryan