Have any of you ever used a router jig to round pen blanks? If so, are you satisfied with the results? I once saw a design for such a device but can no longer find it.
A simple 1/4" rounding bit on a router table would do it, but I don't see the point. It gets round faster on the lathe. And frankly, you have to be careful running something that small through a router anyway. You'd have to use push blocks. By the time you set up, you could have a finished pen.
I have used a roundover bit on the router table to round the edges on some of my more elaborate segmented blanks. I did this to help reduce the risk of blow outs during the rounding process. As others have mentioned, push blocks are a must with something that small. Pretty pointless for most blanks though.
Some one made a thing for that some time ago, don't remember who it was, might have been PSI. ANyway, it looked like two plastic 'wheels' that you could put a mandrel in between, set a router up on a table and use the height adjustment for depth of cut, then just 'rolled' the jig with the wood over the bit to 'turn' it.
I am still looking for thr box that it is hidden in. I cleaned the shop last month and this is what I get for doing it. I will post as soon as I can find it.
The device for turning with a Router table was called a "Tompkins Turner" and Paul in OKC described it exactly. This is the tool I used to turn my first pens. That is until I sold enough to but a Carbe Tech Mini lathe! The tool was fun but lots of work, after cutting down to size (lots of router height adjustments), I had to hand sand and polish. Quite the experience!!
I tried to find one on the "net" last week to show my club but got a big "0" for search results.