panini
Member
Aloha, I'm looking to buy some o-rings for barons. The hardware stores and auto parts store are pricey and can't buy them cheap. Looking to buy about 25-30 o-rings.
O-rings
- Thread starter panini
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
Ligget
Member
And everyone talks about us Scottish folks being thrifty with money! lol:clown:
jcollazo
Member
Mark, what size are these rings? I have a couple bags of o-rings from a project that didn't pan out.
fernhills
Member
I have about 10 o rings from the Classic Rollerball from PSI you can have, if they would fit. Carl
randyrls
Member
Mark; Check for industrial suppliers; MSC, Enco, and McMaster-Carr spring to mind. They sell the o-rings in bulk MSC sells 100 ea for about $3.65
I quote them because they are just down the road from me.
jdmyers4
Member
What size o-ring do I ask for?
livertrans
Member
http://www.penturners.org/forum/showthread.php?t=8127&highlight=baron+rings
Here is an old posting on the subject. I purchased some at Ace Hardware a while back and they were not very expensive .
Here is an old posting on the subject. I purchased some at Ace Hardware a while back and they were not very expensive .
Mikey
Member
Someone in that thread said it was a size 47. 047 o-rings are like 4" in diameter.
YoYoSpin
Member
Randy_
Member
Different vendors use different numbering system for their O-rings so you need to know actual OD/ID measurements to be sure you are getting the correct size.
I looked at #47 O-rings in my local hardware and they weren't anywhere close to being the correct size!!