gothycdesigns
Member
Hello, been a while since I've been to the forum. Well I decided to get a Jacobs drill chuck for my tail stock. Thought this might be better for drilling out the blanks. Since I have not used one before. Any pointers? Suggested speeds fast or slow and such. Till now have used my drill press but does tend to walk and then I get a off centered hole by the end on some materials. I have the drill press bed leveled as best as I can.
Thanks for your time and any suggestions. Also would there be any tutorial videos showing this process?
Ray
P.S. I have a Nova 1624-44 lathe that i'm using this for, if this helps you to know what I am working with. The jacobs chuck was purchased at local Woodcraft, can't think of the brand at this moment. But it was the one most recommended to use. ThX !!
.
Thanks for your time and any suggestions. Also would there be any tutorial videos showing this process?
Ray
P.S. I have a Nova 1624-44 lathe that i'm using this for, if this helps you to know what I am working with. The jacobs chuck was purchased at local Woodcraft, can't think of the brand at this moment. But it was the one most recommended to use. ThX !!
.
Last edited: