allenworsham
Member
I had to make up a bunch of Sierra's for gifts and used some recycled tubes from some previous blanks that I turned down to the brass. I have the finished blanks (well, almost finished as I have to do the final sand & such before assembly today now that the CA has cured) all sitting on my table saw and noticed that 1 of them is noticably shorter than the others. I know the Sierra is pretty forgiving with it's sizing as I have used recycled tubes before with no problems, but this one is noticeably shorter and is in some nice BOW which I would hate to lose.
So does anyone know the minimum legth of the tube to make the sierra work without doing any funky modifying? If I do have to modify it, how would I go about it?
Thanks.
So does anyone know the minimum legth of the tube to make the sierra work without doing any funky modifying? If I do have to modify it, how would I go about it?
Thanks.