thostorey
Member
I turned and assembled a slimline and all went without a hitch until I slid the upper barrel over the transmission. When I twisted the barrel to extend the ballpoint, I found the barrel to be loose and would not properly grip the transmission. I ended up having to apply a pinhead drop of solder to a couple of spots around the diameter of the tx tube, then filing the solder down a bit until the barrel would slide on with a tight fit. [8D]
This particular kit is one of the $1.49 efforts sold by AS. Anyone else experience this? or was this a 'one of' problem.
This particular kit is one of the $1.49 efforts sold by AS. Anyone else experience this? or was this a 'one of' problem.