broitblat
Member
I've just finished a batch of pens in which I experimented with different fills after laser engraving (Ken Nelsen did the laser work). Some were easier to work with than others...
Madrone Burl with Aluminum powder
Although the powder is fine, it was hard to maintain a uniform fill. I think the metal powder doesn't wick the glue as well as stone. The aluminum also turned my buffing wheel black.
Myrtle with Chrysacola
The stone, here, was not as fine as the others.
Thuya Burl with Brass Powder
Maple Burl with black crushed stone
Grey box with black crushed stone
I got the most uniform fill with this one.
Sycamore with acrylic paint
Any comments appreciated.
Madrone Burl with Aluminum powder
Although the powder is fine, it was hard to maintain a uniform fill. I think the metal powder doesn't wick the glue as well as stone. The aluminum also turned my buffing wheel black.
Myrtle with Chrysacola
The stone, here, was not as fine as the others.
Thuya Burl with Brass Powder
Maple Burl with black crushed stone
Grey box with black crushed stone
I got the most uniform fill with this one.
Sycamore with acrylic paint
Any comments appreciated.