avbill
Member
I just turned a bow lower half of a pen. It had a crack in the blank and I thin CA'ed it every few minutes. It is ready for finishing and the crack still shows. This is even after sanding with 220 and CA glue.
What would you do now the crack is visible its about 1" long and a 1//64th wide.
I thought about inlaying a turquoise powder. Or I could turn another BOW blank and sand the turning for the powdered saw dust. And then inlay the sawdust. Any other ideas?
thanks
What would you do now the crack is visible its about 1" long and a 1//64th wide.
I thought about inlaying a turquoise powder. Or I could turn another BOW blank and sand the turning for the powdered saw dust. And then inlay the sawdust. Any other ideas?
thanks