D DozerMite Banned Joined Jun 26, 2007 Messages 1,568 Jun 8, 2008 #1 This is another aluminum knob. This one has a piece of my cast PR in it. Didn't take time to clean it. All comments welcome.
This is another aluminum knob. This one has a piece of my cast PR in it. Didn't take time to clean it. All comments welcome.
ahoiberg Member Joined Apr 10, 2007 Messages 1,763 Location Ames, IA, USA. Jun 8, 2008 #2 cool looking knob. what type of knob is it?
D DozerMite Banned Joined Jun 26, 2007 Messages 1,568 Jun 9, 2008 #3 I was just wasting some time and had a piece of aluminum so I chuched it up and started turning. I think I will fit it to the handwheel on the tailstock of the lathe. This will be much easier after I get a metal lathe.
I was just wasting some time and had a piece of aluminum so I chuched it up and started turning. I think I will fit it to the handwheel on the tailstock of the lathe. This will be much easier after I get a metal lathe.