Richard Gibson
Member
Was making a stylus for my wife and it blewout right as I was finishing. I have segmented a couple of pieces together to replace the broken piece so I decided to Take a break from pens to finish some various Christmas presents.
Making some desk name plates for fellow co-workers. Also made a doll cradle and bathroom stool for little ones in the family. Got them finished and decided to get a little ahead.
I have an order for a new classic for first of the year. Got everything set and decided since I was drilling go ahead and drill the one trustone I've had for a year for myself. Was going to put it on an Emporer. Sure not much room for the drill bit on the 3/4" blank the drilling went fine till the very end and blew out the end. Going to have to wait and get a 7/8" blank from Ed and try again. :befuddled: time to give it up for today.
Making some desk name plates for fellow co-workers. Also made a doll cradle and bathroom stool for little ones in the family. Got them finished and decided to get a little ahead.
I have an order for a new classic for first of the year. Got everything set and decided since I was drilling go ahead and drill the one trustone I've had for a year for myself. Was going to put it on an Emporer. Sure not much room for the drill bit on the 3/4" blank the drilling went fine till the very end and blew out the end. Going to have to wait and get a 7/8" blank from Ed and try again. :befuddled: time to give it up for today.