DKF
Member
Hello All:
I asked this in another forum, probably the wrong one, so I will ask here. I have a Jr. Gent from CSUSA, and when drilling the large diameter blank with the 15/32" bit, the hole ends up larger and with more tolerance than I would consider acceptable. Did they change their bit size for this to a 12.5mm? (I read that in another post).
Any advice or suggestions? Thanks
I asked this in another forum, probably the wrong one, so I will ask here. I have a Jr. Gent from CSUSA, and when drilling the large diameter blank with the 15/32" bit, the hole ends up larger and with more tolerance than I would consider acceptable. Did they change their bit size for this to a 12.5mm? (I read that in another post).
Any advice or suggestions? Thanks