Larryreitz
Member
I've gotten back into casting more, now that I have a good pressure pot (Woodcraft). Trying to replace inventory from two very successful show in the past to weeks so, the pot is getting a workout. For the pen shown below I was not thrilled when viewing the demoulded block of Alumilte (should have taken a picture before it was cut up). Never-the-less I figure all I had to lose was some time so, forward I went. As I drilled the holes my perception started to change as I saw what was what was coming out on the drill bit. Hole was painted and the tubes glued in. Turned the pen about an hour ago and I am quite happy with the result. I'd like to hear what others think. Pen is a Diamond Knurl from EB.
![_MG_9759.jpg _MG_9759.jpg](https://www.penturners.org/data/attachments/283/283613-bfc06fb44a8c06c512321a4e3ea0295d.jpg)
![_MG_9757.jpg _MG_9757.jpg](https://www.penturners.org/data/attachments/283/283611-21a22fe6bd9fa50f3d1ea666404c65d0.jpg)
![_MG_9758.jpg _MG_9758.jpg](https://www.penturners.org/data/attachments/283/283612-da14078dc2aa991287c125023b961fc5.jpg)
![_MG_9759.jpg _MG_9759.jpg](https://www.penturners.org/data/attachments/283/283613-bfc06fb44a8c06c512321a4e3ea0295d.jpg)
![_MG_9757.jpg _MG_9757.jpg](https://www.penturners.org/data/attachments/283/283611-21a22fe6bd9fa50f3d1ea666404c65d0.jpg)
![_MG_9758.jpg _MG_9758.jpg](https://www.penturners.org/data/attachments/283/283612-da14078dc2aa991287c125023b961fc5.jpg)