Just wondering if anyone is having trouble with the dye bleeding or fading in some of these laser cut inlay kits? I sand to 600 grit then micro sand with pads. After that I clean my blank with acetone to get all the dirt and sanding dust off it. Then I finish it with boiled linseed oil and ca.I had a piece that was black in my last kit, and it appeared to smudge slightly after finishing.
Am I doing something here that I should not be doing? I would appreciate any advice that the more experienced turners can give me. Thanks.
Am I doing something here that I should not be doing? I would appreciate any advice that the more experienced turners can give me. Thanks.