johncrane
Member
first unscrew body or nib end
Remove ink refill
Find yourself a small steel rod about 4inch long and about 5/64 round l think from memory.
Next push the steel rod all the way thru the transmission wrap some nonslip material around the pen barrel to protect the finish, Now grip the barrel, place the clip near the your finger nails, place your thumb over the cap, Now knock the rod on some thing solid. The thumb over cap stops it flying off. these photos should help
Now with the cap removed you can get too the transmission.
Next you will need a 7mm steel rod.
Don't use (ANY BIGGER ROD) because there is a small brass bush inside the tube. A 7mm rod goes past this bush will no problems.
now with your steel rod in the cap end push out the transmission buy tapping the steel rod onto some thing solid,the same way as before. l use a flat piece of steel, don't forget wrap up the barrel too protect the finish
Remove ink refill
Find yourself a small steel rod about 4inch long and about 5/64 round l think from memory.
Next push the steel rod all the way thru the transmission wrap some nonslip material around the pen barrel to protect the finish, Now grip the barrel, place the clip near the your finger nails, place your thumb over the cap, Now knock the rod on some thing solid. The thumb over cap stops it flying off. these photos should help
Now with the cap removed you can get too the transmission.
Next you will need a 7mm steel rod.
Don't use (ANY BIGGER ROD) because there is a small brass bush inside the tube. A 7mm rod goes past this bush will no problems.
now with your steel rod in the cap end push out the transmission buy tapping the steel rod onto some thing solid,the same way as before. l use a flat piece of steel, don't forget wrap up the barrel too protect the finish