Scooley01
Member
I read a thread earlier on SOYP where a guy did an amazing pen with a bunch of different materials pieced together (http://www.penturners.org/forum/showthread.php?t=43525&page=5) and some of the piecing is angled so it turns to scalloped designs on the lathe.
My question is, how does one make these cuts? The only saw I have is a mini table saw, and it tends to lose a lot of material at the cuts, and makes rough cuts at that, which would make piecing like this very difficult.
My question is, how does one make these cuts? The only saw I have is a mini table saw, and it tends to lose a lot of material at the cuts, and makes rough cuts at that, which would make piecing like this very difficult.