Built up a Sedona today and now want to disassemble to further refine a blotch in the CA finish. The lower tube is the problem. My puch set can fit past one of the nylon screw and trim rings, but that punch is not large enough in diameter to drive the other end fitting (same exact size) out. The best I can seem to do is use a smaller punch which allows the punch to angle into the tube slightly, but it only catches a small portion of one side of the fitting on the other side.
Does anyone have a method for getting this disassembled? I have not worked with a Baron, but it looks (from photos) that the lower tube set up might be similar.
Any help would be appreciated.
Stan
Does anyone have a method for getting this disassembled? I have not worked with a Baron, but it looks (from photos) that the lower tube set up might be similar.
Any help would be appreciated.
Stan