yorkie
Member
Never seen figure this extreme before.
I almost gave up on it three times, as it was so fussy and full of different densities. Drilling the long blank was tough as it was slightly less than 1/2"x1/2", I just made it by a 1/16" wider than the bushing. I had to finish with sandpaper and had to fill a couple of chip outs before it was done.
Finish is CA.
Thoughts?
I almost gave up on it three times, as it was so fussy and full of different densities. Drilling the long blank was tough as it was slightly less than 1/2"x1/2", I just made it by a 1/16" wider than the bushing. I had to finish with sandpaper and had to fill a couple of chip outs before it was done.
Finish is CA.
Thoughts?