CaptainJane
Member
Hello all
I have been drilling my pen blanks using my Jet 1221 lathe. Lately the holes have been elongated on the end where the drill bit first touches the blank. Happens on all size drill bits.
Is there a way to align the jaws on the tool that holds the blank? It is the spinning chuck on the left, not the stationary chuck on the right.
What else could I check?
Thanks in advance.
I have been drilling my pen blanks using my Jet 1221 lathe. Lately the holes have been elongated on the end where the drill bit first touches the blank. Happens on all size drill bits.
Is there a way to align the jaws on the tool that holds the blank? It is the spinning chuck on the left, not the stationary chuck on the right.
What else could I check?
Thanks in advance.