Dan_F
Member
Is there a glue that bonds by fusing the "acrylic" material in pen blanks (similar to model airplane glue), as opposed to super glue or epoxy?
Thanks,
Dan
Thanks,
Dan
This is good STUFF, can't see a seam even on clear acrylics. Takes forever to get, ground shipping only. If you can find it locally, you must be in schaeffer city !
http://www.tapplastics.com/shop/product.php?pid=131
Like CA, this type of glue comes in thin, medium, etc. The thin is like water and does not set up as fast as CA. So, try to find the "not quite so thin" or be prepared to use a "clamping system" of some type to keep your parts from moving.
Not sure which one is pictured, I have used 3 or 4 -- all the cans look the same.
Pay attention to the handling instructions. That stuff is chemically "hot". They confiscated mine at work, unless I wanted to get special biological testing every quarter. I told them they could keep it. I don't use that much acrylic. They used to use it a lot in the model shop before I transfered in there.
Thanks, found some locally at a plastics fabricator and distributor. I got #3, which is water thin, hadn't seen Ed's post, but I think this should work OK. At least with the thin it shouldn't slide around too much.
Dan