BackyardSmokin
Member
Hi All,
I know that these aren't pens, but I am hoping you can help. I turned two pizza cutters. Unfortunately I because I was in a rush, I did not notice that there were chatter issues until I was done.
What would be the best way to get rid of the solution in the photos? I really don't want to put them back on the lathe since the handles are finished. If I have to put it back on the lathe, is there a way to put them in the chuck without damaging them?
Thanks in advanced.
P.S. I have the Oneway Talon chuck that has grippers on the inside.
I know that these aren't pens, but I am hoping you can help. I turned two pizza cutters. Unfortunately I because I was in a rush, I did not notice that there were chatter issues until I was done.
What would be the best way to get rid of the solution in the photos? I really don't want to put them back on the lathe since the handles are finished. If I have to put it back on the lathe, is there a way to put them in the chuck without damaging them?
Thanks in advanced.
P.S. I have the Oneway Talon chuck that has grippers on the inside.