davinci27
Member
So I got intrigued by the whole kitless concept. The pen is blood wood and BOW with a CA finish. It is based on a euro kit. This pen isn't quite as kitless as some, but I replace many of the parts with custom pieces. I've got to work on recessing the clip. Then I can pull parts from other places.
This project did bring up a question though. How do you press pieces into pens that have wooden nibs? I pressed the transmission in before attaching the nib. Then I used the transmission to hold the pen while I finished it. But it was pretty wobbly during the CA application. It would have been nice if I could have finished sanded and aplied CA prior to pressing in th transmission.
This project did bring up a question though. How do you press pieces into pens that have wooden nibs? I pressed the transmission in before attaching the nib. Then I used the transmission to hold the pen while I finished it. But it was pretty wobbly during the CA application. It would have been nice if I could have finished sanded and aplied CA prior to pressing in th transmission.