I'm turning an acrylic blank and almost done.
When I was inspecting the pen, I noticed that there are some small holes in the pen. I'm not sure if they were flaws in the original, or some type of nick. Right now they are filled with dust from sanding and show up as white. Also, I have a crack. I assume this happened when I drilled and I just now saw it.
My question is this. Can I just fill and sand smooth? Do I use CA or something else?
When I was inspecting the pen, I noticed that there are some small holes in the pen. I'm not sure if they were flaws in the original, or some type of nick. Right now they are filled with dust from sanding and show up as white. Also, I have a crack. I assume this happened when I drilled and I just now saw it.
My question is this. Can I just fill and sand smooth? Do I use CA or something else?