Drcal
Member
I want to turn a small 5" X 7/8" spindle with a 1/4" hole on one end and a 1/16" or a 1/8" hole on the other.
I a want to use a 60 degree live center in the tailstock but I don't do much stuff like this and I am not sure what to use in the headstock.
I don't want to use spurs because I don't want the marring on the end and I do not want to part any off. Can I use something like the Oneway Safe Driver or the Safety Drive Center from PSI? Will that hold it without spinning???
Any help is always appreciated.
Carmen
I a want to use a 60 degree live center in the tailstock but I don't do much stuff like this and I am not sure what to use in the headstock.
I don't want to use spurs because I don't want the marring on the end and I do not want to part any off. Can I use something like the Oneway Safe Driver or the Safety Drive Center from PSI? Will that hold it without spinning???
Any help is always appreciated.
Carmen